Six digitally controlled sections of analog processing Frequency response - 3 Hz to 180 kHz on eq section (-3dB points). Dynamic range - 120 dB from maximum output (.5%THD soft clipping) to minimum output. Noise floor with Mix on 0 is typically – 91dBu. Distortion range - between .0006% and 10% at 1KHz, depending on mode and settings. Maximum Input before...
General Sample Rate 192kHz to 12kHz Resolution 24 bits Minimum Delay 0.11 milliseconds Maximum Delay 10 seconds @ 192kHz 160 seconds @ 12kHz Input Max 24dBu, >18k impedance Output Max 24dBu, 50k impedance Insert Send Max 10dBu, 2k impedance Insert Return Max 20dBu, 50k impedance Physical Power +16V 200mA, -16V 100mA
GAIN RANGE (5dB steps) Mic input 10-65dB Hi-Z input -10-45dB Output trim control 0 to +10dB THD+N 1kHz, 22Hz-22kHz BW @ 20dB Gain +20dBu out <0.00085% @ 40dB Gain +20dBu out <0.0010% @ 60dB Gain +20dBu out <0.0050% INTERMODULATION DISTORTION @ 40dB Gain, +20dBu out SMPTE/DIN 4:1 7kHz/50Hz <0.0020 NOISE - REFERRED TO INPUT @ 60dB Gain 50Ohms...
GAIN RANGE Input Trim -10 - +10dB Output Trim -10 - +10dB Compression Threshold Range -15 - +15 dBu Attack Range 3 - 200 ms Release Range 0.03 - 3 s Ratio Range 1:1 - 12:1 Gain Reduction 0 - 20dB THD+N 1kHz, 22Hz-22kHz BW @ 0dB Gain +10dBu out <0.002% INTERMODULATION DISTORTION @ 0dB Gain +20dBu out SMPTE/DIN 4:1 7kHz/50Hz <0.002% OUTPUT NOISE...
MP-500NV Features I/O connections: XLR balanced; high-Z input on front panel (disconnects mic input) Adjustable gain stages: input in 5db steps to 60db; output from -25 to +10db; maximum overall gain 70db; 2 to 3 stages of single ended solid state amplifier gain blocks, depending on gain structure; high-current 70ma Class A bias on output stage Input and...
32EQ features The 32EQ has the full features of the 32-series EQ: Low, Low-Mid, Hi-Mid, and High EQ bands with Gain and Frequency controls Low and High Band "peaking" switches EQ in/out switch Harrison's renowned High- and Low-pass filters with sweepable frequency Filter in/out switch An Internal jumper provides selection of the "vintage" feedback design,...
I/O: Balanced Input and Output through VPR Rack(All measurements with 600 Ohm output load) Bandwidth: +/- 0.5 dB, 20 Hz - 50 kHz THD+N @ 1 kHz, +4 dBu: 0.01% Maximum Level: +24 dBu Signal-to-Noise Ratio: -102 dB EQ Bands: 4 bands, all +/-12 dB Peak/Dip type Q Range: from 0.60 to 0.85 with boost/cup from 0 to +/-12dB Lo: 20 Hz - 200 Hz Lo-Mid: 100 Hz - 1...